Scale Parameters - Adam Equipment CBK Serie Mode D'emploi

EN
4.2

SCALE PARAMETERS

Shortcut to enter this group is to press and hold the [Count] Key for 4 seconds. The display will go
"S1 Un "
directly to
Press [Func] to view the options for the parameter settings. Press [Tare] to confirm the change and then
advance to the next parameter by pressing the [Func] key.
Press [Zero] to return to the group
Parameter section and return to normal weighing.
This group of parameters are used to control the operation of the scale.
Parameter Description
S1 Un Enable or disable weighing units,
will not allow to disable all units, at
least one has to be enabled.
S2 bL Backlight set to always on, always
off or automatic on whenever a
weight is placed or a key is
pressed
S3 AoF Auto Off- Disable or set time
increment to turn off scale
S4 dt Set Time and Date format and
settings
S5 diS Display all weights or only when
stable
S6 Fi Filter setting to slow, normal or
fast
S7 SPS Scale Password- If it is anything
other than 0000 then the user
must enter the password to gain
access to any of the scale
parameter
entered twice when asked. When
complete, it will display "donE".
S8 CAL Calibration
NOTE: The parameter
© Adam Equipment Company 2017
. Press [Func] to view the list of parameters. Press [Tare] to enter a parameter.
"FUnC 3"
settings. Must
"S4 dt"
is not applicable for CBK-M Scales for use in approved applications.
. If you press [Zero] again, the scale will exit the User
Options
kg
g
lb
oz
lb:oz
EL oFF
EL on
EL AU
SLP 0
SLP 1
SLP 5
SLP 10
Enter the time manually
Enter the date manually
ALL
StAb
SLow
nor
FASt
PI _ _ _ _
be
Calibrate the
Section 10.0
9
Default
setting
kg
EL AU
SLP 0
00:00:00
mm:dd:yy
ALL
nor
0000
scale. See -