Assembling Of Scale; Weighing; Before Weighing - Adam Equipment ABW Serie Mode D'emploi

Notice:
•
Avoid extremes of temperature, do not place in direct sunlight or near air
conditioning vents.
•
Battery should be removed if the scale is not used for a long period of time.
•
Do not stack material on the scale when it is not in use.
•
Avoid high humidity that might cause condensation and keep away from
direct contact with water.
•
Static may influence the weighing result, to reduce the static wipe the pan
and the scale with anti-static wipes.
•
When the battery is running low on charge, the battery light will flash Red
every 1 second, when the battery gets very low on charge, the display will
show "BAT LO" and then turn off within 2 seconds.
4.0 SET UP
4.1

ASSEMBLING OF SCALE

•
Put the scale on a stable and even table.
•
Adjust the height of the feet to level the scale; the spirit level bubble should
be in the center of the spirit level.
•
Put the pan support in place, inserting the pan support pins into the holes on
top of the scale. Place the stainless steel pan on the support.
•
Avoid excess force to weighing pan or the load cell could be damaged.
5.0

WEIGHING

5.1 BEFORE WEIGHING

Check the setting of the auto power off function, see section
off function is on, the scale will power off after a period of time if the scale is not
used and it has a stable reading.
© Adam Equipment Company 2020
6. If the auto power
4