Blackmagic Design Updating Ultimatte Smart Remote 4 Mode D'emploi page 7

NOTE If you are updating from a previous version of Ultimatte Smart Remote
Setup from the Blackmagic Design support center, you will see 'remove' and
'repair' options. In this case, keep following steps 3 onwards. If updating after
uninstalling SR4 1.0.5, skip to step 9.
3 Select 'remove' to uninstall the smart remote software. Tap 'remove' again when
prompted. A progress bar will briefly appear as the uninstall process begins.
4 When prompted, ensure the radio button labelled 'close the applications and attempt to
restart them' is enabled, and tap 'OK'.
5 When asked if you want to allow the application to make changes to your device,
tap 'yes'.
6 A progress bar will appear as the uninstallation process completes. Tap 'finish' and then
tap 'yes' to restart your Smart Remote 4.
Installing Ultimatte Smart Remote Setup 7