Installing Ultimatte Smart Remote Setup - Blackmagic Design Updating Ultimatte Smart Remote 4 Mode D'emploi

3 In the maintenance application window, select 'remove all components' and tap 'next'.
Select 'remove all components' and tap 'next'
4 The maintenance application will now let you know it is ready to uninstall. Tap 'uninstall'
and allow the application to make changes to your Smart Remote 4 by tapping 'yes'.
5 Tap 'finish' on the 'completing the smart remote wizard' window.
The Ultimatte Smart Remote 4 software has now been uninstalled.

Installing Ultimatte Smart Remote Setup

The first step is to download the latest Ultimatte Smart Remote 4 Setup software from the
Blackmagic Design support center at www.blackmagicdesign.com/support. Copy and paste the
Smart Remote 4 Setup installer onto a portable USB storage unit, for example a USB flash drive.
Plug the USB drive into the USB port on the front of your Smart Remote 4. Smart Remote 4 will
automatically read the USB drive and open the file explorer.
NOTE The portable storage drive used to install the software on your smart remote
must be formatted as the master boot record using one single partition. Your Smart
Remote 4 recognizes NTFS, exFAT and FAT32 formats.
To install the software:
1 Double tap on the smart remote setup installer icon in the storage drive.
2
Tap 'next' in the setup wizard and follow the prompts until you reach the 'install' option.
Installing Ultimatte Smart Remote Setup 6