Connecting External Dust Extraction; Switching The Dust Blower Function On/Off; Alignment Adapter; Plunge Cuts - Parkside PSSPA 20-Li B2 Traduction Des Instructions D'origine

• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion (level 1 or 0).
• For thin material, hard material (e.g.
Aluminium) and for cutting curves, use
level 0 also.
With the pendulum stroke activated
you can work much faster.
Connecting external
dust extraction
Connecting external dust
extraction:
1. Slide the adapter for external dust
extraction (15) as far as it will go into
the guide rail between the device and
baseplate (5).
2. Connect an approved dust extractor
(not included in delivery) to the adapter
for external dust extraction.
3. If the external dust extractor does not
fit, use the additional reducer (16) if
necessary.
Removing the external dust
extraction:
1. Disconnect the suction tube from the
adapter for external dust extraction
(15).
2. Disconnect the adapter for external
dust extraction (15).
Switching the dust
blower function on/off
1. To switch on the dust blower function,
move the switch (25) for the dust blow-
er function to position
2. To switch it off, move the switch (25) for
the dust blower function forward.
• With the alignment adapter (17), you
Installing the alignment adapter
1 Place the alignment adapter (17) into
2 Fold the alignment adapter (17) to-
Removing the alignment adapter
2. Fold the alignment adapter (17) down
Plunge cuts may only be made in soft ma-
terials such as wood, aerated concrete,
plasterboard, etc. However, this requires a
certain amount of practice and is possible
only with short saw blades.
Plunge cuts are only allowed if the mitre
angle is 0°.
1. Place the front edge of the baseplate
2. Switch the saw on.
3. Slowly saw at an angle into the work-
4. Continue sawing along the cutting line.
5. Turn off the saw and lift it off the work-

Working instructions

.
• Clamp the workpiece. Use a clamping
• Draw a line to specify the direction in
Alignment adapter
can better align with the drawn cutting
lines.
the recess below the baseplate (5).
wards the baseplate so that it clicks
into place on the top edge.
slightly. While doing so, pull it forward
and off the device.

Plunge cuts

onto the workpiece surface.
piece, then bring the saw into a verti-
cal position.
piece after finishing work.
device for small workpieces.
which the saw blade is guided.
GB IE
31