Assembly; Attaching/Removing The Protective Cover; Removing/Inserting The Rechargeable Battery; Checking The Charge Status Of The Rechargeable Battery - Parkside PSSPA 20-Li B2 Traduction Des Instructions D'origine

GB IE
tric tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear pro-
tection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.

Assembly

Only insert the battery once
the battery-operated tool is
fully ready for use.
Attaching/removing the
protective cover
Attaching the protective cover
1. Press the two holders on the protective
cover (11) into the recesses on the ap-
pliance housing. The protective cover
(11) locks into place.
You can fold the fitted protective
cover (11) up by 90°.
Removing the protective cover
2. Carefully press the two holders on the
protective cover (11) apart.
3. Pull the protective cover (11) to the front.
28
Removing/inserting the
rechargeable battery
1. To remove the battery (21) from the
device, press the release button (20) on
the battery and pull the battery (21) out.
2. To insert the battery (21), push the bat-
tery (21) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Checking the
charge status of the
rechargeable battery
The state of charge display (22) indicates
the state of charge of the battery (21) by
illuminating the corresponding LED(s). To
see this, press the soft button next to the
battery charge level indicator (22).
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged

Recharging the battery

Allow a hot battery to cool before
charging.
PLG 20 A4
Charging
PLG 20 C1
time (min.)
PAP 20 B1
60
PAP 20 B3
90
1. Remove the battery (21) from the appli-
ance, as necessary.
2. Insert the battery (21) in the charging
compartment of the battery charger (23).
PLG 20 A3
PDSLG 20 A1
30
60