Checking The Battery Charge Level; Initial Use; Fitting/Changing The Saw Blade; Fitting The Protective Cover - Parkside PSTDA 18-Li B2 Traduction Du Mode D'emploi D'origine

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
power
RED/ORANGE = medium charge/power
RED = low charge – charge the battery

Initial use

Fitting/changing the saw blade

Remove the battery before carrying out any
work on the power tool (e.g. maintenance, tool-
changing, etc.) as well as during carriage and
storage of the power tool.
Unintentional depressing of the On/Off button can
result in injury.
♦ Push the protective cover
outer holders and pull it off toward the front.
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
its initial position. The saw blade is now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!

Fitting the protective cover

Mount the protective cover
the machine to the dust extraction.
♦ Mount the protective cover
in such a manner that the two outer holders
engage in the openings on the casing.
♦ Remove the protective cover
without dust extraction as well as when perform-
ing mitre cuts. For this, push the protective cover
together at the two outer holders and pull it
off toward the front.

Fitting the guide fence

The guide fence can be fixed on the left- or
right-hand side of the appliance.
PSTDA 18-Li B2
All manuals and user guides at all-guides.com
to
as follows:
together at the two
and hold it in
it must return to
before connecting
onto the machine
for applications
♦ Undo both the locking screws on the insertion
openings .
♦ Push the guide fence
openings .
♦ Re-tighten the two locking screws.
Connecting the sawdust extraction
device
♦ Push the extraction nozzle
extraction duct until it is secured.
Optional depending on the diameter of the dust
and sawdust extractor.
♦ Attach an approved dust and sawdust extractor
to the extraction nozzle
Supporting the extraction function:
♦ Slide the sawdust blower switch

Sawdust blowing function

Switching the sawdust blowing function on:
♦ Press the sawdust blower switch

Fitting the splinter guard

The splinter guard can prevent fraying of the
surface while sawing wood. The splinter guard
can only be used for certain saw blade types,
without the sliding shoe
angles of 0°.
♦ Press the splinter guard
baseplate (notch facing upwards).

Fitting the sliding shoe

When working on sensitive surfaces, you can fit
the sliding shoe on the baseplate
scratching the surface.
♦ Mount the sliding shoe
and press it up at the back until it clicks into
place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
forwards.
into the insertion
into the vacuum
.
to the rear.
forwards.
and only for cutting
from below into the
to avoid
onto the baseplate
.
, unfasten it at
and slide it off
31
GB