Table des Matières
Publicité
Sailmaker Instructions
07/08/09
Halyard Shackle
Manille de Drisse
Fall-Schäkel
Grillo Drizza
Head Shackle
Manille de Tétière
Kopf Schäkel
Grillo Penna
Feeder Entrance
Engougure
Einfädler Öffnung
Feeder
Tack Shackle
Manille d'Amure
Fuss-Schäkel
Grillo Mura
Luff Tape • Tack and Head Shackles • Suncover
■ Sail Type
The Harken furler will work with conventional sails or
ones built with a foam luff.
■ Luff Length
Note offsets above and below the sail.
A shorter luff may be required if a halyard restrainer is
necessary (page 44 - 45) or a toggle or link plates are
used (page 14 - 15) below the furler to raise the drum.
If the luff of the sail is not long enough to put the
halyard swivel near the top of the headstay foil,
make sure a pendant is added, see page 44 - 45.
■ Tack Setback
Note setback for the tack shackle and cut the sail
accordingly.
■ Luff Tape Size
Unit 00AL requires number 6 (
■ Luff Tape Length
Note feeder height and extend the bottom of the luff tape
downwards so it is below the feeder. This will prevent
the luff tape from catching in the feeder as the sail is
lowered. *The 33" (838 mm) minimum pertains to
shortened bottom foil installation, see page 20 - 21.
Other installations will have a minimum feeder height
of 38" (965 mm).
■ Tack and Head Shackles
Make sure tack and head
shackles fit the sail rings.
The minimum inside
dimensions of the standard
head and tack shackles are:
(A) 1
/
" (29 mm) and
1
4
(B)
/
" (13 mm)
1
4
■ Suncover
Suncovers may be installed on
either side of the sail. However,
make sure you match other
sails in the customer's
inventory.
Unit 00AL
/
" or 5 mm) luff tape.
6
32
A
B
Actual Size
Echelle 1
Tatsächliche Grösse
Dimensioni Reali
11
Publicité
Table des Matières
