Appliance Installation; Removing The Appliance; Electrical Connection - Stiebel Eltron CON 5 Premium Utilisation Et Installation

INsTALLATION
Installation
f Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f Mark holes 3 and 4 on the installation wall.
f Drill the holes at the 4 markings.
f Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.

10.3 Appliance installation

1 Wall mounting bracket
f Hook the appliance onto the bottom tabs of the wall mount-
ing bracket by the slots in the back of the appliance.
f Place the appliance in an upright position.
f Secure the appliance by pushing it towards the wall until it
audibly snaps into place in the two upper springs on the wall
mounting bracket.
1
1 Appliance
2 Locking screw
f Secure the appliance against unintentional release using the
supplied locking screw on the right or left-hand side of the
wall mounting bracket.

10.4 Removing the appliance

f Undo and remove the locking screw from the wall mounting
bracket.
f To release the appliance, push down the springs at the top of
the wall mounting bracket.
f Tilt the appliance away from the wall and lift it off the bottom
tabs on the wall mounting bracket.
24 | CON Premium | CON Premium U

10.5 Electrical connection

1
10.5.1 CON Premium series
The appliance is delivered fully wired. The following electrical
connections are permissible:
Connection to a freely accessible standard socket
with matching plug
Permanent connection to an appliance junction box
with earth conductor
Connection to a standard socket
2
1 Retainer for power cable
f Plug the appliance into a standard socket.
WARNING Electrocution
- Carry out all electrical connection and installation
work in accordance with relevant regulations.
- In the case of a permanent connection, the appli-
ance must be able to be separated from the power
supply by an isolator that disconnects all poles with
at least 3 mm contact separation.
- Do not install the appliance with a fixed power
cable.
Material losses
- Observe the type plate. The specified voltage must
match the mains voltage.
- Ensure the on-site supply cable has an adequate
cross-section.
1
Material losses
The power cable must not be pushed into the space be-
tween the appliance back panel and the wall on which
it is installed.
f Wind up any surplus power cable around the cable
retainer at the back of the appliance.
CON 5-30 Premium
X
X
www.stiebel-eltron.com