Electrical Connection; Commissioning; Troubleshooting; Appliance Handover - Stiebel Eltron CK 20 Trend LCD Manuel D'utilisation Et Installation

INSTALLATION

Commissioning

12.4 Electrical connection

WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
Material losses
!
The specified voltage must match the mains voltage.
f Observe the type plate.
The appliance is supplied fully wired (with a mains plug), but it is
also suitable for permanent connection.
12.4.1 Connection to a socket
Material losses
!
The power cable must not hang in front of the air dis-
charge.
f Wind up any surplus power cable and stow it in the
cable compartment at the back of the appliance.
1 Cable compartment
f Insert the power plug of the appliance into a suitable socket.
12.4.2 Permanent connection
WARNING Electrocution
In the case of a permanent connection, ensure the ap-
pliance can be separated from the power supply by an
isolator that disconnects all poles with at least 3 mm
contact separation.
Material losses
!
f Trim the power cable so it leads directly to the appli-
ance connection socket.
f Ensure that, after trimming the power cable, the
appliance can still be removed from the wall without
a problem.
Material losses
!
This appliance is unsuitable for fixed electrical cables.
f Trim the power cable by cutting off the plug.
f Connect the power cable to a suitable socket.
24 | CK 20 Trend LCD
All manuals and user guides at all-guides.com
13. Commissioning
The appliance is ready for operation as soon as it has been fixed
to the installation wall and plugged into the mains.
f Remove the protective film from the programming unit.

14. Troubleshooting

The power cable must only be replaced (for example if damaged)
by a qualified contractor authorised by the manufacturer, using
an original spare part.

15. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety instructions. Hand over the operating and
installation instructions to the user.

16. Specification

16.1 Dimensions and connections

1
g01
g02
131
275
g01
Air intake
Air discharge
202
g02
CK 20 Trend LCD
www.stiebel-eltron.com