3.12 TX Mode Selection
Turn on the dual band standby. Suppose you use Frequency A as main channel, but receiving
signals from Frequency B , you can set the radio to answer on Frequency A ,or on frequency B.
1. Press [MENU], "εEζU" appears, next line is blank. Then press [UP] orΝ[τηWζ]ΝtoΝselectΝ"TXΝ
εητE"έ
2. Press [MENU] to enter into setting, first line shows "TXΝεητEΝSET", next line shows the
status.
3. Press [UP] orΝ[τηWζ]ΝtoΝselectΝ"BUSY or ερSTER"Νέ
4. Press [MENU] to confirm storing and return, or press [*/BAND] to exit without changes.
Note:
σhooseΝ"BUSY" if you like to answer a call on the present frequency directly.
σhooseΝ"ΝερSTER" , no matter what signals radio receives from any channels, the radio
will always answer only on the Main Frequency .
3.13 PRI SET
(Priority channel)
1. Press [MENU], thenΝpressΝ[Uθ]orΝ[τηWζ]ΝtoΝselectΝ"θRIΝSE"έ
2. Press [MENU] to enter into setting , firstΝlineΝisΝ"θRIΝSET", next line shows the status.
3. Press [UP] or [DOWN] to select number 01-99 as a priority channel.
4. Press [MENU] to confirm storing and return,or press [*/BAND] to exit without changes.
Note: 01-99 are channel numbers.