Integrated Cleaning Programme - Melitta Caffeo CI Mode D'emploi

Cleaning and maintenance
Cleaning parts of the milk system
It is recommended to clean the milk
container, milk distributor and the cover
of the front milk distributor regularly,
in addition to the "Intensive Cleaning
programme".
■ Disconnect the tube from the outlet.
■ Flip open the outlet forwards.
■ Pull the milk unit downwards in the
direction of the arrow and out of the
outlet (Image G).
■ Remove the front cover from the milk
distributor (Image H).
■ Rinse the individual parts with hot water.
■ Reassemble the parts in reverse order.

Integrated cleaning programme

The integrated cleaning programme (takes
about 10 minutes) removes residues and
coffee oil residues that cannot be removed
by hand. The progress bar on the text
display 4 shows the current progress of
the cleaning programme.
The cleaning programme should be
performed every 2 months or after
200 brewed cups of coffee, at the latest,
however, when a corresponding message
appears on the text display 4.
Only use Melitta
cleaning tabs.
■ Flip up the lid of the water tank 6.
■ Pull the water tank 6 up and out of the
appliance.
■ Fill the water tank 6 with tap water up to
the max. mark.
■ Reinsert the water tank 6.
■ Connect the tube to the drip tray and to
the outlet (Image D).
■ Call up the Care sub-menu.
■ Select Cleaning in the menu.
■ Select Start in the menu. The cleaning
programme starts.
34
PERFECT CLEAN
®
Operating Instructions: Melitta
■ Empty the drip tray and coffee grounds
container in between and reinsert them.
■ If the message "Place a vessel with 0.7 l
capacity under the outlet" appears on
the text display 4, place a corresponding
vessel under outlet 3.
■ Two rinsing processes will be executed.
■ If the message "Add cleaning tab to the
ground coffee chute" appears on the
text display 4, open the lid of the ground
coffee chute, throw in a cleaning tab
(Image I) and close the lid again.
■ The cleaning programme will continue
(approx. 5 minutes), water fl ows out of
the outlet and in the drip tray inside the
appliance.
■ When the message "Empty tray and
vessel" appears on the text display 4,
empty the vessel under the outlet and
the drip tray. Then reinsert them both.
■ After the cleaning programme is
fi nished, the appliance is ready for
operation.
CI
® ®
| 1834-0618 | 2018-08