Getting Ready To Sew; Connecting The Power Supply; Controlling Sewing Speed - Alfa Compakt 500E Manuel D'instructions

q
e
t
w
r
u
y
6

GETTING READY TO SEW

Connecting the Power Supply

NOTE:
Before connecting to the power supply, make sure the
voltage shown on the machine conforms to your
electrical power.
Turn the power switch off.
Insert the foot control plug into the foot control jack.
Insert the machine plug into the machine socket.
Insert the power supply plug into the wall outlet.
Turn the power switch on.
q Power switch
w Foot control plug
e Foot control jack
r Machine plug
t Machine socket
y Power supply plug
u Wall outlet
NOTE:
Make sure that the foot control plug fit horizontally into
the groove of the foot control jack.
When the power is turned on, the indicator window will
show a test pattern then will indicate 01.
WARNING:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise the
machine will run intermittently.

Controlling Sewing Speed

Pressing on the foot control can vary sewing speed. The
harder you press the foot control, the faster the machine
runs.
NOTES:
Keep the foot control free from accumulation of lint, dust
and loose cloth.
Do not place anything on the foot control.