Hendi 274101 Mode D'emploi page 4

• Always turn the appliance off before disconnecting the plug.
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced phys-
ical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.
Putting the appliance into use
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Place the appliance on a level and steady surface,
unless mentioned otherwise. Two of the three feet
of the base unit can be adjusted in height to level
the appliance.
• Do not place the chocolate fountain near an air-
EN
conditioning duct, open door or window. Cool air
will solidify the chocolate and stop the evenly flow
of chocolate.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
Instructions for use
• Turn on the heating element to preheat the choc-
olate fountain.
• Prepare 700 grams of chocolate as follows:
- Put the chocolate in a heat-resistant bowl.
- Put the bowl in a pot with warm water (60°C).
NOTE! Don't let the water boil.
- Stir the chocolate until is has melted completely.
Do not add water to or spil water into the choc-
olate.
- The chocolate has to be fluid (like yoghurt). If that
is not the case, add some tasteless vegetable oil
(sun flower) to it.
• Turn on the motor and pour the chocolate into the
lower bowl.
• The screw moves the chocolate up.
• You can start now.
4
• Position the appliance in such a way that the plug
is accessible at all times.
• Unpack the chocolate fountain.
• The packaging contains a base unit, a fountain
pipe with two dishes and a screw.
• Clean all parts thoroughly with a wet cloth and and
dry them with a soft cloth.
• Place the screw on the base unit: place the screw
on the triangular shaped axle of the base unit.
• Place the fountain pipe over the screw and line up
the three holes of the fountain pipe with the pins
on the base unit while placing the fountain pipe on
the base unit.
• The chocolate fountain is now ready for use.
• Only use fruit that is sufficiently cooled and has a
dry surface. The low temperature of the fruit helps
the chocolate to solidify and the dry surface helps
the chocolate to attach easier to the fruit. To much
moist/water will deteriorate the consistancy of the
chocolate.
Note! Air bubbles in the fountain pipe disrupt the
evenly flow of chocolate. In which case you must
turn off the motor and wait for the air bubbles to
escape from the fountain pipe (this may take a few
minutes). It is normal for air to escape at the bottom
of the fountain pipe during this procedure. Switch
the motor on again if the fountain pipe is free of air
bubbles.