Intended Use; Ce Declaration Of Conformity - Amann Girrbach ceramill motion 3 Mode D'emploi

M A C H I N E S P E C I F I C A T I O N S
4.1.2

Intended Use

The milling machine is a PC-controlled milling and
E N
grinding machine for the fabrication of dentures
by means of:
_ Dry processing of blanks made of
▪ pre-sintered zirconium oxide
▪ unsintered non-precious metals (NPMs)
▪ Wax
▪ Plastics
_ Wet processing of blanks made of
▪ Sintered glass ceramics
▪ Plastics
Using blanks and tools not approved by the manu-
facturer can damage the machine and make the
product unusable. For such cases, the manufac-
turer shall assume no liability whatsoever.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
A compressed-air connection is required
for operation of milling machine (see
page 45).
Dry processing is permitted only in conjunction
with an appropriate extraction system (for techni-
cal requirements, see page 46).
Wet milling and grinding is permitted only in con-
junction with the supply unit (accessory).
38
4.1.3

CE Declaration of Conformity

This product was designed and manufactured
based on careful selection of the harmonised
standards to be observed, as well as additional
technical specifications. It thus corresponds with
the state-of-the-art and ensures maximum safety.
In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
EC Directives:
_ 2011/65/EU:2011-06-08, RoHS II Directive
_ 2006/42/EG:2006-05-17, Machine Directive
_ 2014/30/EU:2014-02-26, EMV Directive
Applied harmonised standards:
_ DIN EN ISO 12100 Correction 1: 2013-08
_ DIN EN 63000:2019-05
_ DIN EN 55011:2018-05
_ DIN EN 61010-1:2020-03
_ DIN EN ISO 16090-1:2019-12
_ DIN EN 61000-4-4:2013-04
_ DIN EN 61000-4-5:2019-03
The product's declaration of conformity is availa-
ble upon request from the manufacturer.