Regular Inspections; Weekly Maintenance - Amann Girrbach ceramill motion 3 Mode D'emploi

▷ Remove the swarf sieve and dispose of accumu-
lated milling dust/shavings.
▷ Clean the milling chamber and wipe it dry using
a soft cloth.
Damage caused by not removed grinding
residue are not covered by the warranty.
8.1.2

Regular inspections

_ Condition of the bellow
_ Condition of hoses and drain pipes
▷ Keep the door gasket and the stopping surface
on the door clean. Ensure not to damage the
sealing lips.
8.1.3

Weekly maintenance

NOTE:
Danger of damaging the machine!
▷ Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
▷ On the display of the milling machine, select
Maintenance > Clean machine
▷ Follow the instructions on the display.
C L E A N I N G A N D M A I N T E N A N C E
Spindle
The provided spindle service set and the collet
torque wrench are required for maintenance of
the spindle.
Fig. 19 Service set for spindle
1 Collet grease
2 Collet brush
3 Felt cone
4 Ejector pin
5 Torque wrench for collet
▷ On the display of the milling machine, select
Maintenance > Clean chuck
In order to clean the spindle:
▷ Remove any dust from the cap, the C/L pipes
and the spindle using a dry, soft cloth. Do not
.
use cleaning agents!
To remove the collet:
▷ Apply collet torque wrench [5] to collet.
Fig. 20
5
4
1
2
3
.
5
E N
59