Amann Girrbach ceramill motion 3 Mode D'emploi page 50

A P P L I C A T I O N A N D O P E R A T I O N
6.1 Switching between wet and dry processing
The milling machine can be used both for wet and
E N
dry processing.
6.1.1 Switching from dry to wet processing
1
Fig. 13
1 Extraction hood
2 Lever of the extraction hood
3 Swarf sieve
4 Splash guard
5 Lever of the splash guard
▷ Disengage lever [2] and pull off the white
extraction hood [1] toward the front.
▷ Connect the extraction hose to the extraction
opening in the milling chamber.
▷ Activate the extraction system via the display
Service > Exhaustion
under
▷ Vacuum out the milling chamber.
50
2
.
In delivery condition, it is set up for dry process-
ing.
4
When the milling chamber is clean:
▷ Deactivate the extraction system via the display
Service > Exhaustion
under
▷ Pull off the extraction hose.
▷ Insert the cleaned swarf sieve [3].
The wide side faces toward the rear.
For wet processing, it is mandatory to use
the swarf sieve [3]. The sieve serves as the
first coolant/lubricant stage for coarse
particles.
▷ Check if the outlet holes of the C/L nozzles are
unobstructed.
5
3
.