Program Execution; Checking The Workpiece During A Running Program - Amann Girrbach ceramill motion 3 Mode D'emploi

6.3

Program execution

Before executing a program, it must first be
loaded (see CAM software). After loading, a new
job appears on the milling machine display.
▷ Start the new job on the display of the machine
Start job
with .
The program can be stopped:
▷ On the display of the milling machine, press
Pause job
.
To continue the program:
▷ With the door of the milling chamber closed,
Continue job
press on the display.
The program is continued at the position where
it was stopped.
On completion of the program, the machine
returns to the starting position.
A P P L I C A T I O N A N D O P E R A T I O N
6.4 Checking the workpiece during a
running program
▷ On the display of the milling machine, press
Pause job
.
The program is interrupted. The spindle moves
to the rear.
▷ Open the milling chamber door.
▷ Visually check the workpiece.
▷ Close the milling chamber door.
▷ On the display of the milling machine, press
Continue job
The tool is picked up again. The spindle travels
to the position, where the program was inter-
rupted.
.
E N
53