Replacement Parts; Definitions; Ordering; Pt-31Xl And Pt-31Xlpc Replacement Parts - ESAB PT-31XL Manuel D'instruction

SECTION 5
5.1 Definitions
"XT" Consumables
- Used with currently produced product (HandyPlasma 380, HandyPlasma 550, PCM-500i, PowerCut
650, Caddycut and HandyPlasma-50), and older products dating back to 1990.
Standard Consumables / Heavy Duty Consumables
PCM-50 and PCM-31) and consumables configurations. These are the original consumables designed for the torch.
High Performance Nozzle
Extended Life Nozzle
5.2

Ordering

To ensure proper operation, it is recommended that only genuine ESAB parts and products be used with this equipment.
The use of non-ESAB parts may void your warranty.
Have the plasma power source model number and serial number handy if there are any questions concerning required
parts.
Replacement parts may be ordered from your ESAB Distributor.
Be sure to indicate any special shipping instructions when ordering replacement parts.
Refer to the Communications Guide located on the back page of this manual for a list of customer service phone numbers.
5.3

PT-31XL and PT-31XLPC Replacement Parts

1. The PT-31 torch is used on several different cutting packages which require different torch trigger connection configura-
tions as shown in Figure 5-1 and Table 5-1.
2. The PT-31 torch is adaptable to standard, heavy duty or XT consumables to meet specific cutting applications. See
Subsections 5.3.1, 5.3.2 and 5.3.3.
3. Individual consumable parts can be ordered as needed if spare parts kits do not fit current needs.
In most cases, it is recommended that you order the same consumable parts that were shipped with your plasma cutting
system.
- Gives maximum cutting thickness and speed capability.
- Gives extended nozzle life at the expense of top end cutting thickness and speed capability.
- Available for support of pre-1990 year machines (PCM-32i,
85

REPLACEMENT PARTS