Replacement Parts; General; Ordering; Definitions - ESAB PT-31XL Manuel D'instruction

sEctIoN 5
5.0

replacement parts

5.1

general

Always provide the serial number of the unit on which the torch will be used. The serial number is stamped on the
unit nameplate.
5.2

ordering

To ensure proper operation, it is recommended that only genuine ESAB parts and products be used with this
equipment. The use of non-ESAB parts may void your warranty.
Replacement parts may be ordered from your ESAB Distributor.
Be sure to indicate any special shipping instructions when ordering replacement parts.
Refer to the Communications Guide located on the back page of this manual for a list of customer service phone
numbers.
Bill of material items that have blank part numbers are provided for customer information only.
5.3

Definitions

"xt" consumables - Used with currently produced product (HandyPlasma 380, HandyPlasma 550, PCM-500i, PowerCut
650, Caddycut), and older products dating back to 1990.
standard consumables / heavy Duty consumables - Available for support of pre-1990 year machines (PCM-32i, PCM-50
and PCM-31) and consumables configurations. These are the original consumables designed for the torch.
high performance Nozzle - Gives maximum cutting thickness and speed capability.
Extended life Nozzle - Gives extended nozzle life at the expense of top end cutting thickness and speed capability.
5.4

pt-31xl and pt-31xlpc replacement parts

1. The PT-31 torch is used on several different cutting packages which require different torch trigger connection configura-
tions as shown in Figure 5-1, 5-2 and Table 5-1.
2. The PT-31 torch is adaptable to standard, heavy duty or XT consumables to meet specific cutting applications. See
Subsections 5.4.1.
3. Individual consumable parts can be ordered as needed if spare parts kits do not fit current needs.
In most cases, it is recommended that you order the same consumable parts that were shipped with your plasma cutting
system.
Hardware items should be available through local sources.
Note
79
rEplacEMENt parts