Electrical Diagram - Dynamic Senior DMX Serie Notice D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

User guide Senior DMX

CARE

The appliance can be cleaned using a

sponge or a slightly damp cloth.

To clean the inside of the bell, run the

appliance with the tube and its bell in clean

water for 3 seconds.

Clean the stand in clean water using

washing up liquid if necessary.

Be carreful : risk of cuts when clea-

ning the mixer attachment equip-

ped with the blade.

NEVER clean the appliance using a hose.

NEVER immerse the motor block in liquid.

MAINTENANCE

It is preferable to regularly check:

- That the power cable is in good condi-

tion (the copper wires in the cable

should not be visible).

- That the tube is watertight (by visual-

ly inspecting the seal condition after

having removed the blades).

- That the blades are sharp.

If the power cable is damaged, it must be

replaced by the manufacturer, its after-

selfs service or people of similar qualifica-

tion to avoid danger.

ELECTRIC REQUIREMENTS

The mixer of a class 2 category (double

insulation) powered by a single phase

alternating current and does not require a

"u" ground plug.

551250 G20M

The installation must be protected by a

ground fault circuit breaker and a 10 A

calibre fuse.

Use a standard 10/16 A single phased

socket.

Check that the electricity supply voltage

and the value on the mixer specifications

plate are compatible.