Control Connections - ESAB CC-11 Manuel D'instruction

SECTION 3
3.2

Control Connections

An 8­pin receptacle J1 is provided on the rear panel to supply the CC­11 with 115 Vac control voltage for pump
motor contactor control . The CC­11 is normally supplied with this control voltage in order for the pump and fan
to operate . J­1 also provides contact closure signals for a satisfied 1 .00 gpm (3 .8 l/min) flow switch (pins D and C)
and coolant level switch satisfied (pins E and H) .
CAUTION Do not intermittently operate the pump motor as this will cause need-
less wear to the pump.
8­Pin Female Plug
64
INSTALLATION