Fire Hazard - ESAB CC-11 Manuel D'instruction

SECTION 1
WARNING
ELECTRIC SHOCK ­ Can kill .
­ Install and earth (ground) the welding or plasma cutting unit in accordance with applicable standards .
­ Do not touch live electrical parts or electrodes with bare skin, wet gloves or wet clothing .
­ Insulate yourself from earth and the workpiece .
­ Ensure your working stance is safe .
FUMES AND GASES ­ Can be dangerous to health .
­ Keep your head out of the fumes .
­ Use ventilation, extraction at the arc, or both, to take fumes and gases away from your breathing zone
and the general area .
ARC RAYS ­ Can injure eyes and burn skin .
­ Protect your eyes and body . Use the correct welding / plasma cutting screen and filter lens and wear
protective clothing .
­ Protect bystanders with suitable screens or curtains .

FIRE HAZARD

­ Sparks (spatter) can cause fire . Make sure therefore that there are no inflammable materials nearby .
NOISE ­ Excessive noise can damage hearing .
­ Protect your ears . Use earmuffs or other hearing protection .
­ Warn bystanders of the risk .
MALFUNCTION ­ Call for expert assistance in the event of malfunction .
READ AND UNDERSTAND THE INSTRUCTION MANUAL BEFORE INSTALLING OR OPERATING.
CAUTION
CAUTION
To avoid personal injury and/or equipment
damage, lift using method and attachment
points shown here.
WELDING AND PLASMA CUTTING CAN BE INJURIOUS TO YOURSELF AND
OTHERS. TAKE PRECAUTIONS WHEN WELDING OR CUTTING. ASK FOR
YOUR EMPLOYER'S SAFETY PRACTICES WHICH SHOULD BE BASED ON
MANUFACTURERS' HAZARD DATA.
PROTECT YOURSELF AND OTHERS!
This product is solely intended for plasma cutting. Any other
use may result in personal injury and / or equipment damage.
58
SAFETY PRECAUTIONS