Safety, Care, Accuracy Test And Disposal; Safety And Protection - Microlife BP W100 Mode D'emploi

Masquer les pouces Voir aussi pour BP W100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Error
Description Potential cause and remedy
«ERR 3» No pres-
An adequate pressure cannot be generated in
sure in the
the cuff. A leak may have occurred. Check that
cuff
the cuff is correctly connected and is not too
loose. Replace the batteries if necessary.
Repeat the measurement.
«ERR 5» Abnormal
The measuring signals are inaccurate and no
result
result can therefore be displayed. Read
through the checklist for performing reliable
measurements and then repeat the measure-
ment.*
«ERR 6» MAM Mode There were too many errors during the
measurement in MAM mode, making it impos-
sible to obtain a final result. Read through the
checklist for performing reliable measure-
ments and then repeat the measurement.*
«HI»
Pulse or cuff
The pressure in the cuff is too high (over
pressure too
299 mmHg) OR the pulse is too high (over
high
200 beats per minute). Relax for 5 minutes
and repeat the measurement.*
«LO»
Pulse too
The pulse is too low (less than 40 beats per
low
minute). Repeat the measurement.*
16
* Please immediately consult your doctor, if this or any other problem
occurs repeatedly.
If you think the results are unusual, please read through the
information in «Section 1.» carefully.

8. Safety, Care, Accuracy Test and Disposal

Safety and protection

• Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device and
keep for future reference.
• This device may only be used for the purposes described in these
instructions. The manufacturer cannot be held liable for damage
caused by incorrect application.
• This device comprises sensitive components and must be treated
with caution. Observe the storage and operating conditions
described in the «Technical Specifications» section.
• Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight

Publicité

Table des Matières
loading

Table des Matières