REFILL BY STARTER PINCES
Connect the clamps of the GYSCAP 680E to an operational vehicle respecting the polarities.
Start the vehicle.
Press the Power button.
The bars on the digital display will increment and the battery voltage will be displayed.
When all bars are displayed the GYSCAP 680E is ready for further troubleshooting.
After switching off the GYSCAP 680E with the button
Disconnect the GYSCAP 680E clamps from the vehicle.
Wrap the cables and store the clamps in the space provided.
CIGARETTE LIGHTER CHARGING
To facilitate recharging, the GYSCAP 680E is delivered with a cable to connect directly to the vehicle's cigarette lighter
socket. It is then possible to optimally recharge the GYSCAP 680E in a few tens of minutes.
i
This method is recommended for an additional load. In case the GYSCAP 680E is com-
pletely discharged, it is quicker to connect to the battery of an operational vehicle.
Additional charge: 20 minutes
Full Charge: 4 Hours
Connect the GYSCAP 680E cigarette lighter cable to a vehicle.
The bars on the digital display increment, the GYSCAP 680E recharges.
- The additional charge is completed in a few tens of minutes.
- The complete recharge is done in a few hours.
The digital display shows «End» and «CH» simultaneously. The GYSCAP 680E is ready for further
troubleshooting.
GYSCAP 680E is loaded.
Unplug the cigarette lighter plug to turn off the GYSCAP 680E.
12
GYSCAP 680E
:
EN