Using The Foot Pedal - MINN KOTA POWERDRIVE V2 Manuel De L'utilisateur

Moteur de pêche à la traîne monté sur l'étrave
Masquer les pouces Voir aussi pour POWERDRIVE V2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING THE FOOT PEDAL

All the controls in the foot pedal are easy to operate by either foot or hand. A light touch is all that is necessary.
MOMENTARY
A toe touch on the momentary button turns the propeller
on. Let up and the propeller stops.
MOMENTARY/CONSTANT (MOM/CON) SWITCH
When the switch is in CON position the motor will run
continuously without keeping your foot on the pedal. Slide
the switch to momentary (MOM) to again operate the
motor with toe touch.
RIGHT/LEFT
Place your foot in the center of the steering pedal, rocking
to the right steers right. Rocking to the left steers left.
The heel of your foot can also be placed on the deck of the
boat. Using your heel to pivot on, depress and hold the
center momentary to turn the motor on or depress and hold the left or right side of the pedal to steer left or right.
NOTE: The steering system is designed to turn your motor 360°. Be careful to avoid over-wrapping the coil cord around the
composite shaft.
FORWARD/REVERSE
The propeller always turns in the forward direction. You can reverse the direction of thrust by turning the motor 180˚.
SPEED CONTROL
The speed selector is the calibrated sliding bar located on the right side of the foot pedal. The speed selector provides variable
speed control with the built in pulse modulation system. Use your hand or foot to slide the bar forward to increase speed. Draw
the bar back to decrease speed. The slider also contains a roller to aid in fine speed adjustment. Slide your foot over the roller
with light down pressure to adjust speed. The motor may not start turning until the speed slider reaches speeds 1 or 2. This
depends on manufacturing tolerances and if the CoPilot accessory is installed.
NON-CARPETED BOAT USE
Enclosed with your motor are four (4) rubber bumpers. If the foot pedal is to be used primarily on non-carpeted surfaces, insert
the rubber bumpers into the keyhole slots on the underside of the pedal. Slide the bumpers into the slot until they are locked into
position.
©2015 Johnson Outdoors Marine Electronics, Inc.
Steering
Right
Steering
Left
Momentary/Constant
Switch
Speed
Control
Momentary
On/Off
minnkotamotors.com | 13

Publicité

Chapitres

Table des Matières
loading

Table des Matières