EUROM Force 2200 IND Manuel D'instructions page 42

and squeeze the handle. Allow the machine to operate until no more water
comes out of the jet lance. Then switch the machine off immediately. Never
allow it to 'run dry'!
 Remove the plug from the socket, wind the hose up and hang the cable on the
hook.
 Place the handle and the lances in the holders on the machine.
 The machine must be stored frost-free. If this is impossible, have the machine
suck in anti-freeze before you store it. Remember to flush the machine
thoroughly with water before using it again! If the machine nevertheless freezes,
have it checked before use. Frost damage is not covered by the guarantee.
Never start a frozen high-pressure cleaner!
Safety features
The nozzle is fitted with a 'lock' for safety. If you push the button to the left, the
handle is locked and will not function. Unlock the handle by pushing this switch
back to the original position.
The motor is fitted with a thermal safety feature that switches it off when it
overheats. In principle, it will start again automatically when it is sufficiently cooled.
But it is better to switch the machine off for 5 to 10 minutes, wait, and then start it
again. Identify the cause of the overheating and remove it. If this problem recurs,
stop using the machine and contact your supplier / repair service.
The pressure regulator can reduce the pressure when it exceeds the values set
by the manufacturer.
Maintenance
Attention: Always take the plug out of the socket before you execute
maintenance!
 Flush the water supply hose, the high-pressure hose, the jet lance, the nozzle
and other accessories thoroughly before you use them.
 Carefully remove dust, sand or other dirt from the connections.
 Thoroughly rinse and clean the accessories that you have used for spraying.
 Regularly clean the nozzle with the pin supplied and then flush it thoroughly
(against the direction of the jet). To do this you must remove the nozzle from
the lance.
 Regularly clean the filter in the water inlet. To do this, unscrew the water inlet
connector, remove the filter with a screwdriver or similar tool and check that it is
undamaged. Fasten everything firmly and correctly in the appropriate place.
Never use the cleaner without a filter!
 Keep the ventilation openings of the machine clean in order to prevent
obstruction of the cooling function.
 Regularly grease the O-rings of the connectors in order to prevent them from
drying out.
42