EUROM Force 2200 IND Manuel D'instructions page 40

Attention!
 Place the cleaner as close as possible to the water supply.
 The cleaner must be placed on a strong, flat and horizontal surface (handle up).
 The water supply must supply at least the water consumption of the machine
(440 l/h)! The pump must always be supplied with sufficient water. 'Dry
operation' causes damage.
 The water temperature may not exceed 40°C. The pressure of the water
supplied may not exceed 0.7 MPA (7 bar).
 Only use clean water with this machine. Impurities or aggressive chemicals
damage the machine!
Operation
 Turn the On/Off switch to the O position.
 Check that the specifications of the socket that you wish to use correspond with
those on the type plate of the machine. If this is the case, insert the plug into
the socket.
 Open the water supply completely.
 Unlock the safety lock by pushing the button to the right
 Now squeeze the trigger for several seconds in order to de-aerate the hose.
 Switch the machine on by switching the On/Off button to I. The motor will start
briefly, but will stop again as long as the trigger is not squeezed.
 Now squeeze the trigger – the machine will start.
 The automatic start/stop system means that the motor only works when
the trigger is squeezed.
 The jet produced by the jet lance can be adjusted from narrow to wide by
turning the head of the lance. Never do this while spraying!
 The rotating heaD creates a narrow rotating jet.
 The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such
as terraces, small streets, steps, (garden) walls, etc. The cap provides protection
from water splashing back. Attention: the powerful jets can damage softer
materials such as paint and wood, etc!
Using chemicals
This machine is fitted with an integrated chemicals tank. If you wish to add a
cleaning agent to the jet water, take the following actions:
 Remove the cap with the small hose from the tank and fill this tank with cleaning
agent. Replace the cap and check that the end of the small hose is hanging in
the cleaning agent.
 Fit the normal jet lance onto the jet pistol (not the cleaning head or terrace
cleaner!) and adjust it to the lowest pressure by pulling the nozzle forwards (see
diagram).
 When you use the jet the cleaning agent will now automatically mix with the
water and escape through the nozzle.
Important: Always point the jet down!
40