Water Tank; Maintenance - Sonnenkonig FRESCO 100 Mode D'emploi

Sleep control function
• When in cooling mode, press the «Sleep» (1) key to set the temperature. It will increase by 1° C after an hour
and at most it will increase by 2° C after 2 hours.
• Press the «Sleep» (1) key again can to cancel the setting.
Watertank
• The integrated water tank collects excess condensation water produced during air conditio-
EN
ning and dehumidification. The unit has a warning function which, by means of an acoustic si-
gnal and the illumination of the LED light (W.F.), indicates that the water tank must be emptied.
To empty the tank, move the appliance over a drain or container and remove the screw cap and the sili-
cone plug (white) at the bottom of the appliance. Tilt the appliance slightly to allow the water to drain off.
Finally, reconnect the cover and put the appliance back into operation.
Direct Drainage
• You can drain the water directly during operation by using the direct drain (see partial description). Use
a Ø 1.5 cm plastic hose (not included in the scope of delivery.) Make sure that the hose cannot slip and
has no leaks before connecting it to the appliance and starting operation.

6. MAINTENANCE

Caution
• Before cleaning, make sure to disconnect the device from any electrical outlet.
• Do not use gasoline or other chemicals to clean the device.
• Do not wash the device directly.
• If the air conditioner is damaged, please contact the dealer or repair shop.
Air filter
• If the air filter becomes clogged with dust/dirt, it should be cleaned once every two weeks
• Disassembly: Open the air inlet grille and take out the air filter.
• Cleaning: Clean the air filter with a neutral detergent in lukewarm (40 °C) water and dry it up in the shadow.
• Assembly: Put the air filter back into the inlet grille, place the components back as they were before.
Cleaning the surface of the air-conditioner
First clean the surface with a neutral detergent and a wet cloth, then wipe it with a dry cloth.
52