Operating Instructions - Sonnenkonig FRESCO 100 Mode D'emploi

5. OPERATING INSTRUCTIONS

Before starting to operate the device
• Find a place where there is a power supply nearby.
• Install the exhaust hose as shown in Fig. 5 and Fig. 5 A and adjust the window position well.
EN
Fig. 5 Fig. 5 A Fig. 6
• Insert the power plug into a grounded AC220-240V/50Hz socket.
• As shown in Fig. 6, connect the drain hose well (only applicable for using a heating model).
• The dehumidifi er/air conditioner shall be installed on a fl at surface and with empty space all around. Do
not block the air outlet, and make sure the distance around the device is at least 30 cm.
Exhaust hose installation
1. Twist both ends of the exhaust hose into the square fi xing clip and the fl at fi xing clip.
2. Insert the square fi xing clip into the openings on the back of the air conditioner (Fig. 7)
3. Put the other end of the exhaust hose near the window sill.
Fig. 7
50