Sonnenkonig FRESCO 100 Mode D'emploi page 51

Operating temperature range
DB/WB (° C)
Caution for cooling and dehumidifying operations
• When using the cooling and dehumidifying functions, wait for at least 3 minutes between each ON/OFF.
• Make sure the power supply meets the requirements.
• Ensure the socket is suitable for AC.
• Do not share one socket with other appliances.
• Ensure the power supply is AC220-240V, 50Hz
Auto Mode
According to the current room temperature, the device is automatically selecting the required mode: cooling,
dehumidifying or fan (see table). The auto mode is always active if you do not chose any other specific mode.
Room Temperature (Tr)
Mode
Set Temperature
Cooling operation
• Press the «Mode» button (4) fino a quando il simbolo «Cool» si appears.
• Press the button
• Press the «Speed» (7) button to select the wind speed.
Dehumidifying operation
• Press the «Mode» (4) button until the "Dehumidify" icon appears.
• The selected temperature is automatically set to the current room temperature minus 2° C (16° C – 31° C).
• The fan motor is automatically set to low wind speed.
Fan operation
• Press the «Mode» button (4) until the «Fan» icon appears.
• Press the «Speed» (7) button to select the wind speed.
Timer operation
Timer OFF setting:
• When the air conditioner is ON, press the TIMER button and select a desired OFF time by using the tempe-
rature and time setting buttons.
• "Preset OFF Time" is displayed on the operation panel.
• OFF time can be set for any time in 0 – 24 hours.
Swing (air flow)
• After turning on the machine, press the «Swing» (2) key and the air vents will continuously swing up and
down. When this button is pressed again, the movement will stop and the air vents will remain in that
position.
Maximum cooling
35/24
TR < 23° C
Dehumidify
21° C
or to select a desired room temperature (16° C – 31° C).
Minimum cooling
18/12
23° C ≤ 26° C
Fan operation
23° C
51
Tr ≥ 26° C
Cooling
25° C
EN