Cleaning And Maintenance; General Advice; Important - Elba ER 965 IM Mode D'emploi

6

CLEANING AND MAINTENANCE

GENERAL ADVICE

• Before you begin cleaning, you
must ensure that the appliance is
disconnected from the electrical
power supply.
• It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts.
• Avoid leaving
substances (lemon juice, vinegar, etc.)
on the surfaces.
• Avoid using cleaning products with a
chlorine or acidic base.
• Important: The use of suitable
protective
recommended when handling or
cleaning this appliance.
• Clean the surfaces with a damp cloth
and using neutral, non-aggressive
detergents. Complete the cleaning
with a dry, clean cloth.
• IMPORTANT: Never use abrasive
products (e.g. certain type of sponges)
and/or aggressive
caustic soda, detergents containing
corrosive substances)
irreversibly damage the surfaces.
Important: The manufacturer declines all liability for possible damage caused by
the use of unsuitable products to clean the appliance.
Attention!
The appliance gets very hot, mainly around the cooking areas. It is very important
that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the
glass.
44 44
alkaline or acidic
clothing/gloves
products
that could
WARNING: When correctly installed,
your product
requirements laid down for this type of
product category. However special care
should be taken around the rear or the
underneath of the appliance as these
areas are not designed or intended to
be touched and may contain sharp or
rough edges, that may cause injury.
ELECTRONIC PROGRAMMER
DISPLAY CLEANING
Clean the programmer display using a
soft cloth, warm water and neutral soap,
or a soft cloth with a liquid detergent (non-
is
abrasive).
When cleaning, be careful to move the
cloth in one direction only.
Then wipe the display with a damp cloth
and dry it with a soft cloth.

IMPORTANT:

DO NOT use chlorine-based or acid-
based cleaning
products or non-neutral detergents as
they may cause irreparable damage to
(e.g.
the surface. DO NOT spray cleaning
liquids directly on the programmer
display.
meets all safety
products, abrasive