Booster Function - Elba ER 965 IM Mode D'emploi

Cuisiniere en vitroceramique (table de travail a induction)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

"FAST HEATING" FUNCTION
Turn the control knob anti-clockwise to the "A" setting and then release the knob (after the
"beep"); the relative
the knob to the desired power level (between 1 and 9); once a setting has been selected,
and the chosen power level will flash in alternation on the control panel display.
This function allows the cooking zone to operate at the maximum power (100%) for a time
proportional to the selected power level; after this time the cooking zone will operate at the
selected level.
This function is available on all the cooking zones.
While this function is operating it is possible, at any time, to increase the selected power
level but it is not possible to decrease the power; by turning the knob anti-clockwise to a
lower level the function will be disabled.
The function will be disabled also by turning the knob to the "0" (Off) position or by selecting
the "Booster" function.
Note: If removing the pan from the cooking zone before the programme has been completed,
the "Fast heating" function will be completed with the remaining time if the pan is put back
on the cooking zone within 10 minutes.
"BOOSTER" FUNCTION
Turn the control knob clockwise to set the maximum power level (9), then turn clockwise
again to the P setting and release the knob (after the "beep"); the control knob returns to
the maximum setting (9) automatically and the relative
zone display.
The "Booster" program is now operative.
This function allows the cooking zone to operate at the Booster maximum power (above
the nominal power) for maximum 5 minutes; it could be used, for example, to rapidly heat
up large amount of water.
This function is available on the front left/rear right zones.
To disable this function turn the knob anti-clockwise to a lower power level or to the "0"
(Off).
The "Booster" is also disabled by turning the knob again to the P setting; in this case the
cooking zone operates at the power level 9.
Note: if a cooking zone is still hot, it is not possible to use the "Booster" function and
will flash if you try to activate. The cooking zone is automatically set to the maximum power
level (9).
The "Booster" function is always limited to a maximum of 5 minutes. You can activate the
"Booster" function again after 5 minutes.
IMPORTANT NOTES: The "BOOSTER" function is not suitable for use with non water
based cooking.
Do not use this function for heating oil (e.g. deep fat frying)
symbol lights up on the cooking zone display. Within 5 seconds turn
symbol lights up on the cooking
27
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ew 965 imEb 965 imEg 965 imEc 965 imEa 965 imEx 965 im

Table des Matières