Mounting The Remote Control Elements - DT SWISS ODL Mode D'emploi

3.3 Mounting the Remote Control Elements

DE
1. Ensure that the lockout pin is turned until stop in
clockwise direction.
Turn the lockout pin if needed.
EN
R
T
S
2. Slightly grease the o-ring and put it into the
groove on the top of the damping unit.
The o-ring must rest equally in the whole cir-
cumference of the groove.
3. Slightly grease the lockout pin.
T
H
4. Check, if the spring is inserted into the cable guide
correctly.
The horizontally angled arm of the spring must
rest in the slot of the cable guide.
5. Push the cable guide with the spring onto the
damping unit.
If the cable guide can not be fully pushed in, the
o-ring may not be positioned correctly
(see step 2, page 4).
The cable guide must rest fully on the fork
crown.
The cable guide must face in drive direction to
the middle of the fork without touching the
fork crown.
6. Put the end of the spring facing upwards into the
bore of the remote wheel.
7. Put the remote wheel onto the lockout pin.
8. Put a 2 mm Allen key into the hex of the cable fix-
ing screw and turn the remote wheel approx. 180°
until the remote wheel engages behind the rise of
the cable guide.
Push down the remote wheel while turning.
The rise of the cable guide prevents, that the
remote wheel turns backwards.
9. Push the remote wheel down in the engaged posi-
tion and hold it in this position.
10. Remove the Allen key.
12
O.D.L. Forks Remote Transformation V2014.07