DT SWISS ODL Mode D'emploi page 16

11. Screw the fixing nut onto the pin by hand.
12. Turn the remote wheel into the lockout position
using the short end of an angled 2 mm Allen key.
The remote wheel is in the lockout position,
when it touches the cable stop (see picture).
13. Screw on the fixing nut clockwise using a 8 mm
socket wrench.
14. Tighten the fixing nut with a max. torque of 5 Nm.
15. Check the correct assembly of the remote wheel:
Turn the remote wheel with the short end of an
angled 2 mm Allen key.
The remote wheel must turn from the left stop
to the cable stop.
If the remote wheel can not be turned in this
angle, the lockout pin is not positioned cor-
rectly. Dismount the remote wheel and position
the lockout pin again (see step 1, page 4).
16. Check if the spring on the bottom of the compres-
sion wheel is mounted.
17. Put on the compression wheel with the spring fac-
ing downwards and screw on the fixing screw us-
ing a T8 Torx key.
18. Tighten the fixing screw with a torque of 0.5 Nm.
O.D.L. Forks Remote Transformation V2014.07
DE
EN
FR
IT
ES
NL
PT
ZH
13