3 Installation
DE
3.1 Installation of the Remote Lever
EN
1. Carbon handlebars: Apply a thin layer carbon fit-
ting lubricant to the contact area of remote lever
and handlebar.
R
2. Put the remote lever onto the handlebar and
tighten the fixing screw with a torque of 1.5 Nm.
Choose the axial position that fits your needs
best.
T
S
3. Check the proper function of the remote lever and the control elements next to it.
Neither the remote lever nor any other control element may be affected in its proper function.
T
4. Push the remote lever into Pos 1 (see figure).
5. Insert the cable into the remote lever.
Only use uncoated cables!
H
6. Cut the cable housing to the required length.
Only use cable housings with an outer diameter
of 4.2 mm!
7. Check if the handlebar with the installed cable
housing can be turned without being affected.
10
O.D.L. Forks Remote Transformation V2014.07