Spektrum DX2S Mode D'emploi page 19

Tele-BATT
Alert - The Battery Alert setting allows you to preset a
low voltage warning. When the battery voltage in your
receiver drops below the preset voltage, the transmitter
will alert you by beeping. Typical recommended preset
value is 1.1 volt per cell. When using high current draw
servos it may be necessary to reduce that value to .9 volt
per cell.
Recommended voltage settings:
• 5-cell 6.0-volt pack = 5.5 volts
• 4-cell 4.8-volt pack = 4.4 volts
SPEKTRUM DX2S USER GUIDE
Tele-TEMP
Unit - Display Temperature Unit in degree Fahrenheit or
Celsius.
Upper - The Upper selection establishes the maximum
range or boundary of the temperature scale.
Alert - The Temperature Alert allows you to preset an alert
warning when you reach a specified temperature.
Lower - The Lower selection establishes the minimum
range or boundary of the temperature scale.
Note: The Telemetry screen displays the
maximum achieved temperature from the point
that the receiver was turned on. To reset the
maximum temperature, it is necessary to turn
off the receiver, then back on.
EN
19