Travel - Spektrum DX2S Mode D'emploi

EN

Travel

The Travel screen (sometimes referred to as travel adjust
or endpoints) allows independent travel adjustment of the
servo throw in each direction of both channels (steering
or throttle) or ESC on the throttle channel.
To aCCess The Travel funCTIon
From the list screen rotate the Rolling Selector to
highlight the Travel function.
Press the Rolling Selector to enter the Travel function.
The Travel screen will be displayed as shown above.
Rotate the Rolling Selector and highlight the values
desired next to the channel that you wish to adjust.
ST = Steering
TH = Throttle and brake
12
Press the Rolling Selector to enter the highlighted
channel's travel function.
Rotating the Rolling Selector will now adjust both the
upper and lower values simultaneously. If you desire
to adjust the upper or lower directions independently
then move the corresponding channel's wheel or throttle
trigger, and that value alone will be highlighted. For
example, turning the steering wheel to the right will
highlight the right value only and subsequent adjustment
will affect the right travel only.
Note: The DX2S features "sticky gooey."
When the corresponding channel is moved
to the desired position and released, as
illustrated above, the value on that side
remains highlighted. Moving the channel
in the opposite direction will then highlight
the opposite direction's value. This allows
convenient independent travel adjustments
without having to hold the wheel or trigger in
the desired position. To highlight both values
again after moving the control in one direction,
simply press the Rolling Selector twice with
the control centered and both values will be
highlighted.
To return to the main screen press and hold the Rolling
Selector for more than three seconds.
SPEKTRUM DX2S USER GUIDE