Siemens SINUMERIK 840D SL Manuel De Mise En Service page 1402

Configuration du système
2.3 Fichier de configuration "basesys.ini"
; If ExternalIP is empty (default), DHCP is used with the following
; ClientID the default is "@MAC" to use the MAC address,
; alternatives are "@NAME" to use the hostname (Hostname above),
; "@CFID" to use the ID of the CF card if one is available
; (like on X120), or any other arbitrary string
;DHCPClientID=@MAC
[InternalInterface]
; If DisableSysNet is set to 1, the whole interface will
; be disabled
;DisableSysNet=1
; With InternalIP and InternalNetMask (both must be set together),
; you can change the address on the internal/TCU/automation/system
net.
;InternalIP=192.168.214.1
;InternalNetMask=255.255.255.0
; These two can define an alias IP for X120.
;InternalIP_Alias=192.168.216.1
;InternalNetMask_Alias=255.255.255.0
; This defines a "name of station" for ProfiNet (ERTEC interface)
; for use with DCP, default is the normal hostname.
; Please be careful if a PN-Name can also be set by other means,
; for example by NCU-Link. Usually it is not needed to define
; a name here.
;PN_StationName="PN_IO"
; Setting EnableDHCPD_SysNet to 0 suppresses that a DHCP server is
; started on that interface
;EnableDHCPD_SysNet=0
; Set synchronization of all DHCP servers in the
; system/TCU network (X120). Possible values are:
34
Manuel de mise en service, 12/2017, 6FC5397-1DP40-6DA1
Système d'exploitation NCU