EN
Functions
The device has three different vacuuming modes. You can use the corresponding but-
tons on the remote control to select these modes.
You can also use the directional buttons to steer the robotic vacuum cleaner manually.
In each mode, the device will vacuum until the rechargeable battery is low. It will then
automatically locate the charging station.
The robotic vacuum cleaner has the following vacuuming modes:
Random vacuuming mode: The robotic vacuum cleaner will travel straight
ahead until it encounters an obstacle, it will then veer off and travel straight
ahead in another direction.
Spiral vacuuming mode: The robotic vacuum cleaner will begin by trav-
elling from the inside to the outside in an increasingly large spiral. It will
then travel from the outside inward in an increasingly small spiral. Once it
has reached its starting position, it will look for a new area and begin the
process again.
Edge vacuuming mode: The robotic vacuum cleaner will move forward
until it encounters an edge (e. g. wall, piece of furniture), it will then travel
along this edge until it reaches the next edge.
Timer function
– If you do not deactivate the timer and the device is charged, it will always start
cleaning at the set time.
– The device will vacuum in the random vacuuming mode with the timer
function.
You can program the robotic vacuum cleaner so that it starts vacuuming at a desired
time.
1. With the start / pause switch (6) on the device, switch the device to standby mode.
2. Push the
device to vacuum each day.
3. A signal tone will sound, the start / pause switch (6) will illuminate in red and the
device will start vacuuming.
4. If you now switch the device to standby outside of the timer setting, the start / pause
switch (6) will illuminate in red.
5. To deactivate the timer, switch the device to standby mode and push the
on the remote control again. The timer has now been deactivated and the start /
pause switch (6) will illuminate in blue.
05895_DE-EN-FR-NL_A5_V2.indb 28
05895_DE-EN-FR-NL_A5_V2.indb 28
button on the remote control to set the time at which you wish the
28
button
09.02.2017 15:01:13
09.02.2017 15:01:13