Introduction; General Warnings - Iberspa 43639 Manuel D'utilisation

ENG

1. INTRODUCTION

This manual contains essential information for the proper and safe installation and start
up of the system.
Read and strictly follow these instructions. Failure to comply with the instructions may
void your warranty and free the manufacturer from any liability.

2. GENERAL WARNINGS

• A qualified professional must install, start and perform maintenance on the system in
strict adherence to the installation instructions and following all indications given.
• This system may not be plugged into a domestic power line. Verify that the characteristics
of the electrical installation meet the system requirements: 3 phases, 400V between each
phase and 230V between phase and neutral.
• It is mandatory to comply with all applicable electrical safety standards of the country
where the system is installed.
• The safety of people and materials should be ensured. Regulations and established
safety codes must be respected.
• The electrical input of the system should always be protected by a highly sensitive RCD
(Residual Current Device).
• Use only the highest quality connection, which must be grounded.
• It is essential to choose the appropriate cross section for the cables.
• Check that the thermal magnetic circuit breakers have been calibrated according to the
power consumption (amperage).
• Never use the electric control box to connect other equipment.
• No modification is permitted without the express consent of the manufacturer.
• Use only original spare parts supplied by the manufacturer.
• Some elements of the equipment operate at dangerously high voltage. Do not handle
them if the system is not completely disconnected from the power supply and start up
devices are blocked.
• The limit values which appear on the electric switchboard must not, under any
circumstance, exceed the advised amperage.
• Check the wiring and hydraulics before booting the system or connecting it to the power.
• Make sure that no electric component is in contact with water.
• Do not handle the equipment with wet feet.
• Do not switch on the system if the Spa is empty.
7