Operating Instructions; Safety Warnings; Use Warnings - Iberspa 43639 Manuel D'utilisation

5. OPERATING INSTRUCTIONS

5.1. Warnings

SAFETY WARNINGS

• Carefully check the water temperature. Do not use the water at temperatures over 40ºC.
Ideal temperature is 35-36ºC
• Pregnant women, small children, persons with heart conditions, or health problems or
under medical care must not use the spa without first consulting a doctor.
• Take special care if you are alone when using the spa. Prolonged immersion in warm
water may cause nausea, dizziness and fainting.
• Set the spa at a lower temperature if you intend to use the spa for more than 10-15
minutes.
• Do not use the spa after drinking alcohol, taking drugs or medicines that cause
drowsiness or that can raise/lower the blood pressure.
• Be especially careful when getting in and out of the spa when the floor is wet.
• Electrical appliances (radios, hair dryers etc.) must not be used near the spa.
• During use of the spa, keep your head, body and clothes at a distance of at least 40 cm
from the suction intakes. Long hair must be tied back and secured in place.
• Do not start the spa if the protective grilles are broken or missing.
• Only use original spare parts. Any modification requires manufacturer authorisation.
• Check the level off free chlorine and pH before use. Do not use the spa if these levels are
out of normal recommended ranges or if a shock treatment is in process.

USE WARNINGS

Power supply interruption
Should the power supply be interrupted, the system will always automatically restart in
the operating mode it was in before the interruption.
After a power outage the filtration pump will automatically start. Make sure the hydraulic
circuit is ready or connect/disconnect necessary items before starting the system.
Incompatible functions
In order to prevent possible interferences between functions the system software doesn't
allow the following operations:
• When the filtration pump has been activated in manual mode it must also be manually
deactivated before switching on any other pump, or the system will stop and E02 (error
02) will be shown in the main display. Push SET and MANUAL keys consecutively to
deactivate the error message.
• All pumps must be switched off before switching from manual to automatic mode, or
the system will stop and E02 (error 02) will be shown in the main display. Push SET and
20