Units And Massage; Light Control; Remote Control (Spa Buttons) - Iberspa 43639 Manuel D'utilisation

Temperature unit can be changed in the UNITS AND MASSAGE SETTING MENU.

UNITS AND MASSAGE

• When the system is in MANUAL mode Press
the UNITS AND MASSAGE SETTING MENU.
• The 1st parameter, Un (Unit of temperature) will be shown in the display.
Pressing the system will turn to Fahrenheit and pressing
to Celsius. Default unit is Celsius.
• Press to confirm.
• The 2nd parameter, d1 (Duration of massage) will be shown in the display.
Pressing
value is 10 minutes. The measurement unit is the minute.
• Press to confirm.
• The 3rd parameter, d2 (Inhibition time) will be shown in the display. Controls how long
the button that activates the pump is idle after finishing the massage cycle.
Pressing
00 seconds. The measurement unit is the second.
• Press to confirm
• Press or or wait 10 seconds to exit the System Setup Menu.
Parameter
Un
d1 Massage duration time
d2 Massage inhibition time
rn
d3

LIGHT CONTROL

Light is controlled by the LIGHT

5.4. Remote control (Spa buttons)

The pumps can be activated from the spa if the appropriate switches are installed. Each
switch can control one or more pumps at once. Depending on the system's configuration.
• By pressing the corresponding switch the pump begins to operate and does not
stop until the time programmed in parameter d1 (Units and Massage Setting Menu) is
26
the duration of the massage can be increased or decreased. Default
you can choose the massage inhibition time. The default value is
General Parameter Configuration
Description
Temperature units
Nr refill
Refill duration time
button and/or the spa push button (optional).
for 3 seconds and the system displays
Interval Default value
ºC - ºF
00-99 (minutes) 10 minutes
00-99 (seconds) 00 seconds
0 – 2 (s)
00 – 99 (m)
the system will turn
Involved
Function
ºC Temperature
Water/Air massage
Water/Air massage
0 EV load
0 EV load