Maintenance Of The Spotlight; Maintenance In Periods Of Non-Use Or Absence; Maintenance Of The Water; Preparation For Winter - Iberspa SPA DAY DREAM 32473 Manuel De Fonctionnement

UTILIZATION MANUAL

6.4. MAINTENANCE OF THE SPOTLIGHT

A black ABS plastic spanner is provided to dismantle
the projector.
Changing the lamp is the only maintenance required
on the spotlight. To replace the lamp, follow these
steps:
•
Ensure that the main differential is in the OFF
position.
•
Empty the water from the Spa (See section
Drainage ).
•
With your hands turn carefully the spotlight trim to
extract it. This trim is placed without screws.
•
Fit the plastic spanner in the front side of the
spotlight and turn it in order to liberate its fixing
by bayonet.
•
Change the lamp (fixed without screws).
The bulb code is 40R0761.
supplier or specialist shop.
•
Replace the spotlight fixing the bayonet of the
front side with the spanner and pressing enough
to avoid the entrance of water in the spotlight.
•
Replace the spotlight trim.
6.5. MAINTENANCE IN PERIODS OF NON-USE
OR ABSENCE.
SHORT PERIODS (3-5 DAYS)
•
Adjust the pH

"Maintenance of the water").

•
Set the Spa in the "SLEEP" mode.
•
Cover the Spa.
On returning;
•
Readjust the pH and treat the water again.
•
Readjust the desired mode.
PROLONGED PERIODS (5-14 DAYS)
•
Set the temperature at its lowest level.
•
Adjust the pH
"Maintenance of water").
•
Set the Spa in the "SLEEP" mode.
•
Cover the Spa.
On returning;
•
Reset the temperature as required.
•
Readjust the pH and treat the water again.
Contact your
and treat the water
and treat the water

PREPARATION FOR WINTER

If the Spa is not used during winter or for very long
periods, the following operations should be performed:
•
Disconnect the electrical equipment.
•
Locate the drain valve and turn left to the OPEN
position. The Spa will empty by gravity through
the general grain.
•
Spa
Leave the drain valve open.
•
Remove the filtering cartridges (see Maintenance
of the filter) and set in a dry place.
•
Clean and dry the Spa.
•
Cover the Spa.
Do not leave water in the Spa without
electrical
temperatures below 4ºC, as the pipes could
freeze and damage the Spa.
(see
(see
9
connection outdoors
EN
at