Antari W-515D Mode D'emploi page 7

Status of W-DMX connection
Transmitter assigned, DMX signal
received
Transmitter assigned, No DMX
signal
Transmitter link lost or linking to
transmitter
Transmitter not assigned
▪ Setting W-DMX 512 address
When W-DMX function is activated, press button MENU until the display indicates »W-
DMX Address: 001«. Use the buttons UP and DOWN to set the machine to the same
address as on your W-DMX console.
▪ Resetting W-DMX connection
When W-DMX function is activated, press button MENU until the display indicates »W-
DMX Reset OFF«. Use the buttons UP and DOWN to activate the resetting: delete
previous W-DMX connection and relink. Once the deletion and relink are done,
the dispay indicates »W-DMX Reset OFF« again.
▪Switching the run last setting function on and off
Press the button MENU until the display indicates »Run Last Setting ON«. Use the
buttons UP and DOWN to deactivate the fun last setting function (indication »Run
Last Setting OFF«) and to reactivate it (indication »Run Last Setting ON«).
- Continuous operation
Press the button VOLUME, to activate continuous fog output. The display indicates
»Volume Output« followed by the value that was set in the menu item »Volume
Output« or »NONSTOPBURST« when continuous fog output was selected. To stop
the fog output, press STOP button.
NOTE:
When a fog output volume higher than 30 % was set for continuous
operation, the fog machine occasionally needs to stop the fog output to reheat.
When »NONSTOPBURST« was selected, the fog machine adjusts the fog output
volume and heater temeperature automatically and does not need to stop to
reheat.
Symbol on the Liquid
Crystal Display
●
◎
⊙
○