Cleaning And Storage - Antari W-515D Mode D'emploi

W-530D External View
01-Nozzle
02-Handle
03-Body
04-Tank & tank's cap
05-PU tube & filter
06-Tube adaptor
07-Safety ring
08-Control outlet socket
(3 Pin XLR for DMX)
09-Control inlet socker
(3 Pin XLR for DMX)
10-Control outlet socket
(5 Pin XLR for DMX)
11-Control inlet socket
(5 Pin XLR for DMX)
12-Rocker switch / Power
13-Circuit breaker
14-Power socket
15-W-1 wireless receiver
receiver
16-Control panel
17-Foot
18-Power cord
19-W-1 wireless transmitter
Performance Note
All fog machines develop condensation around the output nozzle. Because this
may result in some moisture accumulation on the surface below the output nozzle,
consider this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during operation
and for a minute or so after being turned off.
All fog machines have a recycling period after long bursts when the machine will
shut itself down for a short period in order to heat up again. During this time no
fog can be produced.

Cleaning and Storage

Do not allow the fog liquid to become contaminated. Always replace the cap on
the fog liquid container and the fog machine liquid tank immediately after filling.
Cleaning your fog machine regularly can help you to reduce the frequency of
parts replacement and maintenance costs. After every 40 hours of continuous
/ W-DMX