Set-Up Example - Telecom Behnke 20-3117 Mode D'emploi

5.5. Set-up example

In this example, the intercom buttons are connected to the triphone branch-off box (40-9208)
(max. 8 call buttons).
Relay 1 (here: door opener) is activated for 10 seconds. The relevant pictograms are triggered during
events.
A voice message is played for the person waiting and the person answering the call.
(40-0006 (Basic electronics- triphone), 40-9208 as well as 20-0061 (function without 20-0061 not
possible)
*0000
51 1# Record voice message for the person waiting (cf. technical manual or chapter „Most
important configuration steps" on page 37))
51 2# Record voice message for the person answering the call (cf. technical manual or chapter
„Most important configuration steps" on page 37)
21 telephone no. Key 1 *812
(with voice message for the person waiting/
the person answering the call) # ▸ Enter the telephone no. for the 1st Key
:
28 Telephone number Key 8 *812
(function waiting for the call to be answered
(function waiting for the call to be answered
(with voice message for the person waiting /
the person answering the call) # ▸ Enter the telephone no. for the 8th Key
10 0 #
*
Notice: if you replace the two wildcard characters (XX) behind *8 XX by the number 0 (*8 00),
the voice message will be omitted.
www.behnke-online.com
Connection to triphone basic electronics
▸ Enter set-up mode.
▸ Set 0 as the code to open the door
▸ Exit set-up mode
Special needs Manual
GB
55