Telecom Behnke 20-3117 Mode D'emploi page 42

Special needs Manual
GB GB
Commissioning with analogue basic electronics
Code Parameter
Play a voice message:
52 1 = Play voice msg. no. 1 (short msg.)
2 = Play voice msg. no. 2 (short msg.)
3 = Play voice msg. no. 3 (short msg.)
4 = Play voice msg. no. 4 (short msg.)
5 = Play voice msg. no. 5 (short msg.)
6 = Play voice msg. no. 6 (long msg.)
7 = Play voice msg. no. 7 (long msg.)
8 = Play voice msg. no. 8 (long msg.)
9 = Play voice msg. no. 9 (long msg.)
Upon entering configuration step code 52 and the corresponding no. of the
message to be played, the device will automatically play the message in
question. Playing the message will automatically stop after the message has
elapsed. You may also stop the message playing by pressing the # key.
Please note: You may only play the long messages no.7; 8 and 9 after you have
previously set a corresponding amount of long messages via configuration
step code 50.
Voice message upon activation Relay 1: Default setting: 0
53 0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
This configuration step allows you to set a voice message to be played upon
activation of Relay 1. This, however, is only possible for relay operations modes
1 to 6 or 18 and 19. For relay operations mode 19, the voice message will only
be played when the automatic activation is manually turned on / off. The voice
message will also be played when the special symbols *71 and *73 are used in
a telephone number.
42
Confir-
mation
#
#
#
#
#
#
#
#
#
#
#
:
#
www.behnke-online.com