Telecom Behnke 20-3117 Mode D'emploi page 43

Code Parameter
Voice message upon activation Relay 2: Default setting: 0
54 0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
This configuration step allows you to set a voice message to be played upon
activation of Relay 2. This, however, is only possible for relay operations modes
1 to 6 or 18 and 19. For relay operations mode 19, the voice message will only
be played when the automatic activation is manually turned on / off. The voice
message will also be played when the special symbols *72 and *73 are used in
a telephone number.
Voice message and telephone function: Default setting: 0
55 0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
This configurations step allows you to determine a voice message to be played
while the telephone function is in use. The message will be played until you
start dialling the telephone number on the keypad.
Voice message and code lock function: Default setting: 0
56 0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
This configurations step allows you to determine a voice message to be played
when the code lock function is in use. The message will be played until you
start entering the code on the keypad.
www.behnke-online.com
Commissioning with analogue basic electronics
Special needs Manual
Confir-
mation
#
#
:
#
#
#
:
#
#
#
:
#
GB
43