Telecom Behnke 20-3117 Mode D'emploi page 45

Code Parameter
This configuration step will affect all direct calls including calls via speed dial-
ling and calls from the telephone book.
Example:
Provided that you recorded the following voice messages via configuration step
code 51:
1. Voice message (51 - 1): "Direct call activated."
3. Voice message (51 - 5): "Please hold. Establishing connection."
6. Voice message (51 - 6): "Call from your intercom system."
Making the following entry will result in these messages to be played during a
direct call:
58 1 [beep] 5 [beep] 6 [beep] #
In case the message "Direct call activated." should not be played, make the
following entry.
58 0 [beep] 5 [beep] 6 [beep] #
Voice message and the ### function: Default setting: 10
59
0 = No voice message
1 = Play voice message no. 1
:
9 = Play voice message no. 9
10 = Play the same message that was played after the last time the receiver was
picked up
Via this configuration step you may set a voice message to be played when
during a connected call the DTMF sequence # # # is entered within 5 seconds.
www.behnke-online.com
Commissioning with analogue basic electronics
Special needs Manual
Confir-
mation
#
#
:
#
#
GB
45